Release Submission Daemon
wydawca reads its settings from the
configuration file wydawca.conf. By default it is located
in $sysconfidr (i.e., in most cases /usr/local/etc, or
/etc), but an alternative location may be specified using
--config-file command line option (see config-file).
If any errors are encountered in the configuration file, the program reports them on its error output and exits with a non-zero status.
To test the configuration file without starting the server use
--lint (-t) command line option. It causes
wydawca to check configuration file for syntax errors and
other inconsistencies. If no errors were detected, the program exits
with code 0. Otherwise, the exit code is 78.
Using this option together with -d1 (--debug=1),
wydawca to produce a dump of the configuration parse
tree. Setting a higher debugging level (e.g. -d2 option) will
additionally prefix each statement in the dump with the file location
where it appeared.
Before parsing, configuration file is preprocessed using
m4 (see Preprocessor). To see the preprocessed
configuration without actually parsing it, use the -E command
line option. To avoid preprocessing it, use
The rest of this section describes the configuration file syntax in
detail. You can receive a concise summary of all configuration
directives any time by running
This document was generated on January 6, 2021 using makeinfo.Verbatim copying and distribution of this entire article is permitted in any medium, provided this notice is preserved.