Wydawca (split by node):   Section:   Chapter:FastBack: configuring   Up: configuring   FastForward: wydawca.conf   Contents: Table of ContentsIndex: Concept Index

4.7 Syslog Configuration Directives

Unless told otherwise, wydawca uses syslog to print its diagnostic messages. By default, the program uses the ‘daemon’ facility. The syslog statement allows to change that:

Config: syslog { ... }
syslog {
  facility local1;
  tag wydawca;
  print-priority yes;
}
Config: syslog: facility name

Configures the syslog facility to use. Allowed values are: ‘auth’, ‘authpriv’, ‘cron’, ‘daemon’, ‘ftp’, ‘local0’ through ‘local7’, and ‘mail’. These names are case-insensitive and may be optionally prefixed with ‘log_’ (case-insensitive as well).

Config: syslog: tag string

This statement sets the syslog tag, a string identifying each message issued by the program. By default, the name of the program (‘wydawca’) is used.

Config: syslog: print-priority bool

In addition to priority segregation, provided by syslog, you can instruct wydawca to prefix each syslog message with its priority. To do so, set:

print-priority yes;