SLB User Manual (split by section): Section: Back: 6. Exit Codes Forward: 8. How to Report a Bug Chapter: FastBack: 6. Exit Codes Up: SLB FastForward: 8. How to Report a Bug Doc: Contents: Table of Contents Index: Concept Index   ?

7. Signals

The program handles a set of signals. To send a signal to slb use the following command:

 
kill -signal `cat /var/run/slb.pid`

Replace ‘/var/run/slb.pid’ with the actual pathname of the PID-file, if it was set using the ‘pidfile’ configuration statement.

The ‘SIGHUP’ signal instructs the running instance of the program to restart itself. It is possible only if slb was started using its full pathname.

The signals ‘SIGTERM’, ‘SIGQUIT’, and ‘SIGINT’ cause immediate termination of the program.

SLB User Manual (split by section): Section: Back: 6. Exit Codes Forward: 8. How to Report a Bug Chapter: FastBack: 6. Exit Codes Up: SLB FastForward: 8. How to Report a Bug Doc: Contents: Table of Contents Index: Concept Index   ?
This document was generated by Sergey Poznyakoff on April, 26 2011 using texi2html 1.78.

Verbatim copying and distribution of this entire article is permitted in any medium, provided this notice is preserved.