Simple Load Balancer
|SLB User Manual (split by chapter):||?|
The program handles a set of signals. To send a signal to
slb use the following command:
kill -signal `cat /var/run/slb.pid`
Replace ‘/var/run/slb.pid’ with the actual pathname of the PID-file, if it was set using the ‘pidfile’ configuration statement.
The ‘SIGHUP’ signal instructs the running instance of the program
to restart itself. It is possible only if
slb was started using
its full pathname.
The signals ‘SIGTERM’, ‘SIGQUIT’, and ‘SIGINT’ cause immediate termination of the program.
Verbatim copying and distribution of this entire article is permitted in any medium, provided this notice is preserved.