Mailfromd Manual (split by node):   Section:   Chapter:FastBack: Mailfromd Configuration   Up: Mailfromd Configuration   FastForward: Invocation   Contents: Table of ContentsIndex: Concept Index

7.7 Call-out Configuration

Mailfromd Conf: ehlo-domain string

Sets default domain used in ‘EHLO’ (or ‘HELO’) SMTP command when probing the remote host. This value can be overridden by ‘from’ parameter to poll command (see poll).

This statement assigns the value string to the ‘ehlo_domain’ variable (see ehlo_domain), and is therefore equivalent to

setvar ehlo_domain string;
Mailfromd Conf: mail-from-address string

Sets default email addresses used in ‘MAIL FROM:SMTP command when probing the remote host. This value can be overridden by ‘as’ parameter to poll command (see poll).

This statement assigns the value string to the ‘mailfrom_address’ variable (see mailfrom_address), and is therefore equivalent to

setvar mailfrom_address string;
Mailfromd Conf: enable-vrfy bool

Enables the use of SMTP VRFY statement prior to normal callout sequence. If VRFY is supported by the remote server, mailfromd relies on its reply and does not perform normal callout.

The use of this statement is not recommended, because many existing VRFY implementations always return affirmative result, no matter is the requested email handled by the server or not.

The default is enable-vrfy no, i.e. VRFY is disabled.

Mailfromd Manual (split by node):   Section:   Chapter:FastBack: Mailfromd Configuration   Up: Mailfromd Configuration   FastForward: Invocation   Contents: Table of ContentsIndex: Concept Index