GNU Dictionary Server
7.3 Initialization File
When you start
dico, it automatically executes commands from its
initialization files (or init files, for short), normally
called .dico. Two init files are read: the one
located in your home directory, and the one from the current working
directory. It is not an error if any or both of these files are absent.
These files contain a series of
dico commands, as
described in Interactive Mode, with the only difference that
no command prefix is used by default. The ‘#’ character
introduces a comment: any characters from (and including) ‘#’ up
to the newline character are ignored4.
Init files are useful to change the defaults for your
invocation. Consider, for example, this init file:
# An example init file for
dico# Turn the welcome banner off quiet yes # Set the location of autologin file autologin ~/.dicologin # Use this server by default open dict.org # Search in all databases database * # Finally, set the custom command prefix prefix :
Notice, that if you wish to change your command prefix, it is preferable to do it as a last command in your init file, as shown in this example.
The same holds true for interactive mode as well, but you will hardly need comments on a terminal.
This document was generated on November 21, 2016 using makeinfo.Verbatim copying and distribution of this entire article is permitted in any medium, provided this notice is preserved.